JOHANNEMANN & SONSROOFING · EXTERIORS · CONSTRUCTION
(201) 446-5941 Free Estimate
A copper gutter ending in a decorative dragon-head spout
Service · Upper Saddle River, NJ 07458

Copper Gutters, Gutter Repair & Replacement in Upper Saddle River, NJ

Copper, aluminum and seamless gutters for Upper Saddle River's large roofs.

In detail

An inch of rain on a large roof, say 4,000 square feet, is about 2,500 gallons of water, and on Upper Saddle River’s one-acre lots all of it has to be carried clear of the foundation, the planting and the terraces. Most of the borough’s houses are the colonials, split-levels and ranches of the 1950s and 1960s, many of them enlarged since, so the roofs are big and the gutter runs are long. The cost of copper against aluminum, and how long each lasts, is set out in copper gutters in Bergen County.

Johannemann & Sons covers the full gutter scope in Upper Saddle River (07458): seamless copper and aluminum installation, downspouts sized to the roof, gutter repair, gutter replacement and leaf guards, all tied back to the roof’s edge flashing. Free written estimate; seamless runs formed on site.

In short

Considering copper gutters or a full gutter replacement in Upper Saddle River? Call (201) 446-5941 or request a written estimate online.

On site

Big roofs move a lot of water

Gutter sizing on a large roof is a hydraulics problem, not a default specification. A roof with several wings sends its runoff into a few valleys and long eaves, and an undersized system simply overflows, sending water against the foundation, into the beds and onto the walks below. We size the runs and downspouts to the area of roof that drains to each one, which on many houses here means 6-inch seamless runs rather than the builder-standard 5-inch, with downspouts placed where the roof planes actually shed.

The work

Copper gutters, done properly

Copper suits a slate or copper roof and an older house, and on a large house it is worth pricing against aluminum. It commonly lasts 60 to 100 years, weathers to a patina, and ties cleanly into copper roof valleys, bay flashing and chimney saddles. What goes into a copper system:

01

Half-round or K-style

The profile chosen for the house, with soldered seams and copper hangers throughout.

02

Matched copper downspouts

Sized to the run and set to move the water without overflowing.

03

Formed on site

Runs formed to the length of each roof edge, so the only joints are at corners and outlets.

04

Tied into the roof

Matched to copper valleys, bay roofs and chimney flashing where the roof has them.

In practice

Protecting the grounds on a one-acre lot

On lots this size, the gutter system is really a water-management system for the grounds. Get it wrong and the damage shows up away from the house: eroded beds, saturated lawn, water pooling at the foundation, ice ridges across a walk in winter. We carry the discharge well clear of the house and the planting, and protect the landscape during the work itself. On the lots along East and West Saddle River Roads, where the river’s floodplain runs, where that water ends up matters most.

Specifics

Gutter repair on long runs

Most repairs trace to a short list of failures: runs sagging off the fascia, joints leaking where a run meets a downspout or a corner, downspouts disconnected at the elbow, clogged runs overflowing in heavy rain, and sections bent by ice at the eaves after a hard winter. We find the failure and repair it in matching material: copper to copper, gauge to gauge, profile to profile.

  • Re-pitching & re-securing. Resetting slope lost over the years and replacing failed hangers.
  • Section replacement. Damaged copper or aluminum lengths replaced in matching material.
  • Seam & joint sealing. Leak-tight repair where runs meet downspouts, corners and outlets.
  • Ice and overflow damage. Bent or torn sections renewed, and the cause at the roof edge looked at too.

Cleaning under mature trees

Upper Saddle River’s wooded one-acre lots drop enough leaves that twice-a-year cleaning is a floor, not a ceiling. Left alone, a clogged run overflows and rots the fascia. On the most heavily treed lots we fit leaf guards to stretch the interval.

One exterior

Gutters, the roof, windows and siding work as one system. On a roof replacement or a large roof repair we can do the gutters at the same time, matched to the new edge flashing.

Planning gutter work? Free written estimate for copper installation, repair or full replacement: (201) 446-5941 or request online.

Also in Upper Saddle River

The rest of the exterior

Everything we do in Upper Saddle River → · Gutters in detail →

Questions
How much do copper gutters cost in Upper Saddle River, NJ?

Copper gutters typically run $25-$50 per linear foot installed, depending on the gauge, the profile and the downspouts; a whole house of 150-400 linear feet with matched copper downspouts usually lands between $6,000 and $25,000+. Seamless aluminum costs a fraction of that and is priced after we measure. Free written estimate.

Why copper, and how long does it last?

Copper commonly lasts 60-100 years, and the patina it develops over the first decade or two protects the metal. It is also the natural match for a slate or copper roof, tying valleys, flashing and gutter runs into one material. By comparison, aluminum lasts 20-30 years and steel 15-20.

What size gutters does a large roof need?

Often bigger than the builder default. A large roof sheds a great deal of water in a single heavy rain, so on many houses here we specify 6-inch runs rather than 5-inch, size the downspouts to the area of roof that drains to each one, and add downspouts where a long roof plane concentrates the flow. Undersized gutters overflow, and that water ends up against the foundation and in the planting.

Do you repair gutters, or only replace them?

Both. A repair covers re-pitching sagging runs, replacing damaged sections in matching material, re-securing hangers and sealing leaking joints. Full replacement is right when the system is at the end of its life, when a new roof changes the edge flashing, or when a homeowner is moving up from aluminum to copper.

How often do gutters need cleaning here?

At least twice a year, in late spring and late fall, and more often on the borough's wooded one-acre lots where mature trees drop heavily. A clogged gutter overflows and rots the fascia, so on the most heavily treed lots we also fit leaf guards to stretch the interval.

Free assessment

Copper gutters for Upper Saddle River, NJ.

Free written estimate for copper and aluminum installation, gutter repair and full replacement across the 07458.

(201) 446-5941 Request a written estimate →

Or call — an active leak should not wait on email.
Call (201) 446-5941 Free estimate